The Press Section: Squeezing Out Water
Understand why pressing is the cheapest place to remove water, how felts and nips work, what a shoe press adds, and how to recognize crushing and rewet.
Why Pressing Matters So Much
The web leaves the couch at about 20% solids — still four parts water to one part fiber. Water can leave in only three ways:
| Section | How water leaves | Relative cost |
|---|---|---|
| Forming | Gravity, foils, vacuum | Cheapest |
| Pressing | Mechanical squeezing | Cheap |
| Drying | Evaporation with steam | Most expensive by far |
Every bit of water the press removes is water the dryers don’t have to evaporate. A widely used rule of thumb:
Each 1 percentage point increase in solids leaving the press saves roughly 4% of dryer steam — or lets the machine run faster with the same steam.
That’s why press section performance is watched so closely.
How a Press Nip Works
A press nip is the line of contact between two rolls loaded against each other. The wet sheet travels through the nip sandwiched against a press felt — a thick, porous fabric.
In the nip, pressure squeezes water out of the sheet and into the felt. The felt then has to give that water up — through grooved or blind-drilled roll covers, suction rolls, and uhle boxes (vacuum slots the felt passes over on every revolution).
Rewet
As the sheet and felt leave the nip, the pressure releases and the fiber network springs back slightly, sucking some water back from the felt. This rewet is why sheets and felts are separated as soon as possible after the nip.
Shoe Presses
A conventional roll nip lasts only a few milliseconds. A shoe press (extended nip press) replaces one roll with a stationary concave shoe and a flexible belt, making the nip up to about 10 times longer. More time under pressure means more water removed — often several points higher solids — with less crushing and better bulk preservation, which matters for board stiffness.
Press Felts
Felts are consumables that directly control water removal. A new felt is open and drains well; as it ages, it fills with fines, fillers, pitch, and stickies and compacts.
Felt care includes:
- Showers — high-pressure needle showers and chemical cleaning showers
- Uhle box vacuum and dwell — monitored to track felt condition
- Scheduled changes — usually during planned shutdowns
Common mistake: raising nip load as far as it goes to chase dryness.
Past a point, water can’t escape the sheet fast enough and is forced sideways through it, disrupting the fiber network — called crushing. It shows up as a mottled, blotchy appearance and lost strength. Too much load also compacts felts early and reduces bulk. Higher load is not always drier sheet; find the curve for your grade.
Key Takeaway
The press section takes the web from about 20% to 40–50% solids, and it removes water far more cheaply than the dryers. Felts carry the water away; rewet and crushing are the enemies. Shoe presses extend the nip time for higher dryness with better bulk.
A linerboard machine leaves the press at 44% solids. A new felt raises that to 46%. Using the 4%-per-point rule of thumb, roughly how much dryer steam is saved?
Answer: 2 points × ~4% ≈ 8% less steam. If the dryers were the bottleneck, that could let the machine run several percent faster at the same steam — a big win from a felt change.
1. Why is pressing preferred over drying for removing water?
Evaporation needs a lot of steam energy. Squeezing water out mechanically is far cheaper.
2. What is 'rewet' in the press section?
As pressure releases, the sheet expands and draws water back from the felt. Quick separation reduces rewet.
3. What is the main advantage of a shoe press?
The concave shoe extends the nip dwell time, increasing dryness and preserving bulk.
4. What is 'crushing'?
When water can't escape fast enough, it moves sideways through the web and damages the fiber network.